We finally have the Ender 6 printing – you need to keep the fan on any time the hot end is heating (or it clogs up), low retraction (2mm), and adjust the z offset as it prints the skirt (or brim, we’ve switched to using a brim to ensure adhesion)
Author: Lisa
Mushrooms
There are big clusters of these little mushrooms all over this week
Clearing the Woods
We are clearing the woods by the river so the Ranger can drive along the river (and hopefully over the river). Making a little progress … you can actually see the river through the trees now.
Smoked Ribs
Four different rubs, and smoked this afternoon while we worked.
The larger rack of ribs was perfect, but the smaller ones were pretty overcooked. I made smoked rib chili with them, though, and that worked well.
River Trail
I took the Ryobi cutter along the river and found a Ranger-sized path. We got a tree puller, and have started clearing out the smaller trees by popping them out of the ground. Very fun!
Clean Bench
I pressure washed a few of the benches to see how well the pressure washer would clean them. Pretty well!
Farmhouse Roof, Day 7
We have a roof! Still need downspouts, but the house should be dry finally!
Farmhouse Roof, Day 6
We’ve got shingles! They’re not on the house yet … but they exist 🙂
But the porch roof is covered again!
Farmhouse Roof, Day 4
It’s starting to be more house-shaped …
Farmhouse Roof, Day 2
They’re making progress on repairing the roof …
